A.A.C.V.M.

wesk escribió:The correct Ramsey PTO for the M38 and M38A1 is the 105 and the correct factory winch is the model 50. The 50R was a supply replacement stock item. These two units fit the jeep without any serious modifications.

wesk escribió:The Ramsey model 50 was the correct winch for both the M38 and the A1 from Willys. The military spares system stocked the 50R for field replacement. The model 50 was a 3500 Lb winch and the Model 50R was a 5000 Lb winch.

wesk escribió:The Ramsey 105 PTO and model 50 or 50R winch are hard to find and very pricey. The Model 105 PTO tucks the winch driveshaft in real close to the engine so no modifications of the M38 or M38A1 exhaust are required. The front winch mounting frame fits the model 50 and 50R winches which are considerably narrower then the civvy Ramsey 200 series. The driveshaft is unique to the M38/M38A1 and it's single bearing support that mounts to the bell housing bolts is very hard to find.

The difference between the model 50 original equipment M38 winch and the service replacement 50R which was the original equipment M38A1 winch is the rating and cable lengths. The 50 is a 3500 lb winch and the 50R is a 5000 Lb winch.

pascualmattera escribió:Adrian
te cuento mi soporte lo copie de un amigo que bajo planos
y las medidas son estas
diametro del rodillo 40 mm
alto del rodillo 100 mm
perforacion central 14 mm
estas medidas estan en mm las reales son en pulgadas
el rodillo que tengo es de acero !

si no tenes apuro puedo verificar estas medidas y el material del mismo , dado que en el club se encuentra un soporte
original
saludos pascual